Plast – Bestämning av töjningsegenskaper – Del 2: Provningsbetingelser för press- och sprutmassa (ISO 527-2:2024, IDT)
Status:
Gällande
Köp denna standard
StandardSvensk standard
·
SS-EN ISO 527-2:2025
Plast – Bestämning av töjningsegenskaper – Del 2: Provningsbetingelser för press- och sprutmassa (ISO 527-2:2024, IDT)
Prenumerera på standarder med tjänst SIS Abonnemang. Genom att prenumerera får du effektiv åtkomst till gällande standarder och säkerställer att ditt företag alltid har tillgång till senaste utgåvan.
Läs mer om SIS Abonnemang
1.1 This part of ISO 527 specifies the test conditions for determining the tensile properties of moulding and extrusion plastics, based upon the general principles given in ISO 527-1.
1.2 The methods are selectively suitable for use with the following range of materials in the preferred thickness, or, in case of specimen machined from molded parts in the thickness as molded:
— rigid and semi-rigid thermoplastics moulding, extrusion and cast materials, including compounds filled and reinforced by, for example, short fibres, small rods, plates or granules but excluding textile fibres (see ISO 527-4 and ISO 527-5).
See ISO 527-1:2019, Clause 3 for the definition of "rigid" and "semi-rigid".
— rigid and semi-rigid thermosetting moulding and cast materials, including filled and reinforced compounds but excluding textile fibres as reinforcement (see ISO 527-4 and ISO 527-5);
— thermotropic liquid crystal polymers. The methods are not normally suitable for use with rigid cellular materials or sandwich structures containing cellular material. For rigid cellular materials see ISO 1926.
The methods are not suitable for flexible films and sheets, of thickness smaller than 1 mm, see ISO 527-3.
1.3 The methods are applied using specimens which may be either moulded to the chosen dimensions or machined, cut or punched from injection- or compression-moulded plates. The multipurpose test specimen is preferred (see ISO 20753).
Plast – Bestämning av töjningsegenskaper – Del 2: Provningsbetingelser för press- och sprutmassa (ISO 527-2:2024, IDT)
Prenumerera på standarder med tjänst SIS Abonnemang. Genom att prenumerera får du effektiv åtkomst till gällande standarder och säkerställer att ditt företag alltid har tillgång till senaste utgåvan.
Läs mer om SIS Abonnemang
Internationell titel: Plastics — Determination of tensile properties — Part 2: Test conditions for moulding and extrusion plastics (ISO 527-2:2024, IDT)