Standard Svensk standard · SS-EN 10247:2018

Mikroskopisk undersökning av halten icke-metalliska inneslutningar i stål med användning av jämförelsebilder

Status: Gällande

Köp denna standard

Standard Svensk standard · SS-EN 10247:2018

Prenumerera på standarder med tjänst SIS Abonnemang. Genom att prenumerera får du effektiv åtkomst till gällande standarder och säkerställer att ditt företag alltid har tillgång till senaste utgåvan. Läs mer om SIS Abonnemang

Prenumerera på standarden - Läs mer Dölj

Pris: 1 731 SEK

PDF

Pris: 1 731 SEK

Papper

Pris: 2 769,60 SEK

PDF + papper

Fler alternativ Färre alternativ

This European Standard defines a method of microscopic non-metallic endogenous inclusion assessment using picture charts.
The method does not apply to particles of a length or diameter less than 3,0 µm or a width smaller than 2,0 µm. If defined by a product standard or agreement between the involved parties for certain special products, inclusions with a width below 2,0 µm can be evaluated by length alone.Inclusions with dimensions exceeding the upper limits in Table 2 are evaluated as belonging to the maximum class and noted separately with their true dimensions (see 7.5.6).
It is assumed, if particles are elongated or if there are stringers of particles, that they are parallel to each other. Other arrangements are not covered by this standard. This European Standard applies to samples with a microscopic precipitation approaching random distribution.
From the data of measurements obtained by this method, evaluation according to other standards can be established.
This European Standard does not apply to free cutting steels.
NOTE The basic principle of this European Standard allows the determination of non-metallic inclusion content by image analysis techniques.

Omfattning

This draft European Standard defines a method of microscopic non-metallic endogenous inclusion assessment using picture charts.
The method does not apply to particles of a length or diameter less than 3,0 µm or a width smaller than 2,0 µm. If defined by a product standard or agreement between the involved parties for certain special products, inclusions with a width below 2,0 µm can be evaluated by length alone.Inclusions with dimensions exceeding the upper limits in Table 2 are evaluated as belonging to the maximum class and noted separately with their true dimensions (see 7.5.6).
It is assumed, if particles are elongated or if there are stringers of particles, that they are parallel to each other. Other arrangements are not covered by this draft standard. This draft European Standard applies to samples with a microscopic precipitation approaching random distribution.
From the data of measurements obtained by this method, evaluation according to other standards can be established.
This draft European Standard does not apply to free cutting steels.
NOTE The basic principle of this draft European Standard allows the determination of non-metallic inclusion content by image analysis techniques.

Ämnesområden

Övrigt (77.040.99)

Rabatt	- EUR	- SEK
Summa	EUR	SEK
Frakt	EUR	SEK
Moms	EUR	SEK
Totalt	EUR	SEK

Mikroskopisk undersökning av halten icke-metalliska inneslutningar i stål med användning av jämförelsebilder

Ämnesområden

Produktinformation

Inom samma område