Standard Svensk standard · SS-EN ISO 3747:2009

Akustik - Bestämning av ljudeffektnivåer och ljudenerginivåer hos bullerkällor med användning av ljudtryck - Tekniska-/överslagsmetoder för användning in situ i en efterklangsmiljö (ISO 3747:2000)

Status: Upphävd · Ersätts av: SS-EN ISO 3747:2010

1.1This International Standard specifies a method for determining the sound power levels of sound sources in situ, especially if non-movable. A comparison method is used and all measurements are carried out in octave bands. The measurement uncertainty depends on the test environment. The measurement uncertainty is evaluated by comparing with an indicator describing the spatial sound distribution. The accuracy will either be that of an engineering method or a survey method.

The sound power level of the source under test is calculated from the measured values of the sound pressure levels produced at specified measurement points by the source and by a reference sound source, respectively. The sound power level is calculated using the calibrated values of the reference sound source and the differences between the values obtained with the source under test and those of the reference sound source. All calculations are carried out in octave bands, from which the A-weighted sound power level is determined.

NOTE For noise sources which can be moved, other relevant standards in the ISO 3740 series may be used.

1.2This International Standard is applicable to all kinds of test environments which are to be found outside a laboratory environment, provided that the background noise level is sufficiently low and the sound pressure level at the microphone positions depends mainly on reflections from the room surfaces.

NOTE ISO 3744 or ISO 9614 may provide alternative methods.

1.3 This International Standard is primarily applicable to sources which radiate broad-band noise. It may, however, also be used for sources which radiate narrow-band noise or discrete tones, although the measurement uncertainty might then become larger than stated herein.

NOTE For noise sources emitting stationary noise, ISO 9614 may be used as an alternative.


Buller och mätmetod (14.020) Allmänt Bullermätning (17.140.01)


Språk: Engelska

Framtagen av: Akustik och buller, SIS/TK 110

Internationell titel: Acoustics - Determination of sound power levels of noise sources using sound pressure - Comparison method in situ (ISO 3747:2000)

Artikelnummer: STD-70456

Utgåva: 2

Fastställd: 2009-08-17

Antal sidor: 36

Ersätter: SS-EN ISO 3747

Ersätts av: SS-EN ISO 3747:2010