1. Start

Standard Swedish standard · SS-EN ISO 2538-1:2014

Geometrical product specifications (GPS) - Wedges - Part 1: Series of angles and slopes (ISO 2538-1:2014)

Status: Valid

Tell a colleague about

Scope
This International Standard specifies terms and definitions for wedges, three series of wedge angles from 120° to 0° 30' and a series of wedge slopes from 1:10 to 1:500, for general mechanical engineering purposes.

Subjects

General (17.040.01)

Product information

Language: English

Written by: GPS och verifiering - Toleranser, SIS/TK 507/AG 05

International title: Geometrical product specifications (GPS) - Wedges - Part 1: Series of angles and slopes (ISO 2538-1:2014)

Article no: STD-102860

Edition: 1

Approved: 9/7/2014

No of pages: 24

Replaces: SS-EN ISO 2538 , SS-ISO 2538

Related

Standards
SS-EN ISO 12780-2:2011 Geometrical product specifications (GPS) - Straightness - Part 2: Specification operators (ISO 12780-2:2011)
SS-EN ISO 12781-1:2011 Geometrical product specifications (GPS) - Flatness - Part 1: Vocabulary and parameters of flatness (ISO 12781-1:2011)
SS-EN ISO 1119:2011 Geometrical product specifications (GPS) - Series of conical tapers and taper angles (ISO 1119:2011)
Books and tools
Koordinatmätteknik (E-bok)
Technical Committee
SIS/TK 507 Tekniska produktspecifikationer (TPS)
Swedish Institute for Standards
Box 45443, SE-104 31 Stockholm
Sweden
+46 8-555 520 00
info@sis.se

Visiting address: Solnavägen 1E, 113 65 Stockholm.
LinkedIn
Copyright Disclaimer
Report error on page