1. Start

Standard Swedish standard · SS-EN ISO 1119:2011

Geometrical product specifications (GPS) - Series of conical tapers and taper angles (ISO 1119:2011)

Status: Valid

Tell a colleague about

Scope
This International Standard provides calculated values for a series of cones or conical tapers, ranging from 120° to less than 1°, or ratios from 1:0,289 to 1:500, intended for general use in technical engineering.

It applies only to plain conical surfaces, and excludes prismatic pieces, taper threads, bevel gears, etc.

Subjects

General (17.040.01)

Product information

Language: English

Written by: GPS och verifiering - Toleranser, SIS/TK 507/AG 05

International title: Geometrical product specifications (GPS) - Series of conical tapers and taper angles (ISO 1119:2011)

Article no: STD-82586

Edition: 2

Approved: 12/29/2011

No of pages: 24

Replaces: SS-EN ISO 1119

Related

Standards
SS-EN ISO 2538-1:2014 Geometrical product specifications (GPS) - Wedges - Part 1: Series of angles and slopes (ISO 2538-1:2014)
SS-EN ISO 12780-2:2011 Geometrical product specifications (GPS) - Straightness - Part 2: Specification operators (ISO 12780-2:2011)
SS-EN ISO 12781-1:2011 Geometrical product specifications (GPS) - Flatness - Part 1: Vocabulary and parameters of flatness (ISO 12781-1:2011)
Books and tools
Koordinatmätteknik (E-bok)
Technical Committee
SIS/TK 507 Tekniska produktspecifikationer (TPS)
Swedish Institute for Standards
Box 45443, SE-104 31 Stockholm
Sweden
+46 8-555 520 00
info@sis.se

Visiting address: Solnavägen 1E, 113 65 Stockholm.
LinkedIn
Copyright Disclaimer
Report error on page