Standard Swedish standard · SS-EN ISO 15530-3:2011

Geometrical product specifications (GPS) - Coordinate measuring machines (CMM): Technique for determining the uncertainty of measurement - Part 3: Use of calibrated workpieces or measurement standards (ISO 15530-3:2011)

Status: Valid

Buy this standard

Standard Swedish standard · SS-EN ISO 15530-3:2011

Geometrical product specifications (GPS) - Coordinate measuring machines (CMM): Technique for determining the uncertainty of measurement - Part 3: Use of calibrated workpieces or measurement standards (ISO 15530-3:2011)
Subscribe on standards - Read more Dölj
Price: 919 SEK
standard ikon pdf

PDF

Price: 919 SEK
standard ikon

Paper

Price: 1 470,40 SEK
standard ikon pdf + standard ikon

PDF + paper

Show more Show less
Scope
This part of ISO 15530 specifies the evaluation of measurement uncertainty for results of measurements obtained by a CMM (coordinate measuring machine) and by using calibrated workpieces or measurement standards. It provides an experimental technique for simplifying the uncertainty evaluation of CMM measurements, whose approach (substitution measurements) leads to measurements being carried out in the same way as actual measurements, but with calibrated workpieces of similar dimension and geometry instead of the unknown workpieces to be measured. Non-substitution measurements on CMMs are also covered, as are the requirements of the uncertainty evaluation procedure, the measurement equipment needed, and the reverification and interim check of the measurement uncertainty. NOTE The evaluation of measurement uncertainty is always related to a specific measuring task.

Subjects

Measuring instruments (17.040.30)


Buy this standard

Standard Swedish standard · SS-EN ISO 15530-3:2011

Geometrical product specifications (GPS) - Coordinate measuring machines (CMM): Technique for determining the uncertainty of measurement - Part 3: Use of calibrated workpieces or measurement standards (ISO 15530-3:2011)
Subscribe on standards - Read more Dölj
Price: 919 SEK
standard ikon pdf

PDF

Price: 919 SEK
standard ikon

Paper

Price: 1 470,40 SEK
standard ikon pdf + standard ikon

PDF + paper

Show more Show less

Product information

Language: English

Written by: SIS - Industriteknik

International title:

Article no: STD-82018

Edition: 1

Approved: 10/31/2011

No of pages: 32

Replaces: SIS-ISO/TS 15530-3:2007