Standard Swedish standard · SS-EN 754-8:2016

Aluminium and aluminium alloys - Cold drawn rod/bar and tube - Part 8: Porthole tubes, tolerances on dimensions and form

Status: Valid

Scope
This European Standard specifies the tolerances on dimensions and form for aluminium and aluminium alloy cold drawn porthole tubes with an outside diameter (OD) from 3 mm to 350 mm (round tube, see Figure 1) or with a cross section contained within a circumscribing circle (CD) from 8 mm to 300 mm (other than round tube, see Figure 2), supplied in straight lengths.
This document only applies to cold drawn tube for general engineering applications made in the following alloys:
— EN AW-1050A, EN AW-1200;
— EN AW-3003, EN AW-3103;
— EN AW-5005, EN AW-5005A, EN AW-5049, EN AW-5251, EN AW-5052;
— EN AW-6012, EN AW-6060, EN AW-6061, EN AW-6262, EN AW-6262A;
— EN AW-6063, EN AW-6063A, EN AW-6065, EN AW-6082;
— EN AW-7020.
The temper designations used in this part are according to EN 515.
This document only applies to tube produced by the porthole/bridge method of extrusion only (and then cold drawn to the final dimensions).
This document does not apply to:
— cold drawn tubes produced by the seamless, die/mandrel method (EN 754-7),
— tubes delivered in coils (EN 13958),
— coiled tubes cut to length (EN 13958).

Subjects

Aluminium and aluminium alloys Aluminium products


Product information

Language: English

Written by: SIS - Materialteknik

International title: Aluminium and aluminium alloys - Cold drawn rod/bar and tube - Part 8: Porthole tubes, tolerances on dimensions and form

Article no: STD-8020842

Edition: 3

Approved: 6/13/2016

No of pages: 28

Replaces: SS-EN 754-8:2008