Methods of testing cement - Part 4: Quantitative determination of constituents
Status:
Valid
Buy this standard
StandardTechnical reports
·
SIS-CEN/TR 196-4:2007
Methods of testing cement - Part 4: Quantitative determination of constituents
Subscribe on standards with our subscription service. When you use our service you can be assured the latest editions and easy access.
Read more about SIS Subscriptions
This European Technical Report describes procedures for determining the contents of most of the constituents of the cements that fall within the scope of EN 197-1.
In principle, the method described in Clause 6 applies to all cements, whatever the number and nature of their constituents, but in practice is limited to the cements identified in Table 1.
The method in clause 6 should be considered to be the method of choice and is based on a sequential selective dissolution of the cement’s constituents, generally of an unknown number, where they are not available separately for analysis at the same time as the cement.
The method of choice enables the quantitative determination (by mass) of: Portland cement clinker, blastfurnace slag, siliceous fly ash, natural pozzolans, limestone, silica fume and set regulators in cements of the types identified in Table 1. Table 1 is derived from Table 1 of EN 197-1.
Methods of testing cement - Part 4: Quantitative determination of constituents
Subscribe on standards with our subscription service. When you use our service you can be assured the latest editions and easy access.
Read more about SIS Subscriptions