Standard Swedish standard · SS-ISO 8504-2

Preparartion of steel substrates before application of paints and related products - Surface preparation methods - Part 2: Abrasive blast-cleaning

Status: Withdrawn

· Replaced by: SS-EN ISO 8504-2:2019
Buy this standard

Standard Swedish standard · SS-ISO 8504-2

Preparartion of steel substrates before application of paints and related products - Surface preparation methods - Part 2: Abrasive blast-cleaning
Subscribe on standards - Read more Dölj
Price: 919 SEK
standard ikon pdf

PDF

Price: 919 SEK
standard ikon

Paper

Price: 1 470,40 SEK
standard ikon pdf + standard ikon

PDF + paper

Show more Show less
Scope
This part of ISO 8504 describes abrasive blast-cleaning methods for the preparation of steel surfaces before coating with paints and related products. It also contains information on the effectiveness of the individual methods and their fields of application.
ISO 8504 is applicable to new and corroded steel surfaces and to steel surfaces that are uncoated or have been previously coated with paints and related products. For limitations, see note 2.
NOTE 1 These methods are essentially intended for hot-rolled steel to remove mill scale, rust, etc., but could also be used for cold-rolled steel of sufficient thickness to withstand the deformation caused by the impact of abrasive.
NOTE 2 There are several items that should be included in the purchaser's procurement documents to supplement this part of ISO 8504. Items that should be considered as a part of surface preparation before coating are edge grinding, removal of grease and oil, porosity of welds, removal of weld spatter, removal of burrs and other sharp edges, grinding of welds, filling of pits and other surface imperfections that may cause premature failure of the coating system (see ISO 8501-3 for more information) and the removal of water-soluble contaminants.

Subjects

Surface preparation (25.220.10)


Buy this standard

Standard Swedish standard · SS-ISO 8504-2

Preparartion of steel substrates before application of paints and related products - Surface preparation methods - Part 2: Abrasive blast-cleaning
Subscribe on standards - Read more Dölj
Price: 919 SEK
standard ikon pdf

PDF

Price: 919 SEK
standard ikon

Paper

Price: 1 470,40 SEK
standard ikon pdf + standard ikon

PDF + paper

Show more Show less

Product information

Language: English

Written by: SIS - Materialteknik

International title:

Article no: STD-28512

Edition: 2

Approved: 8/18/2000

No of pages: 21

Also available in: SS-EN ISO 8504-2

Replaces: SS-ISO 8504-2

Replaced by: SS-EN ISO 8504-2:2019