This European Standard has been prepared under the mandate M/109 given to CEN by the European Commissionand the European Free Trade Association.The clauses of this European Standard, shown in this annex, meet the requirements of the Mandate given underthe EU Construction Products Directive (89/106/EEC).Compliance with these clauses confers a presumption of fitness of the construction product covered by thisEuropean Standard for its intended use according to clause 1 (Scope) of this standard.WARNING : Other requirements and other EU Directives may be applicable to the product(s) falling within the scope of this standard.NOTE 1 In addition to any specific clauses relating to dangerous substances contained in this standard, there may be otherrequirements applicable to the products falling within its scope (e.g. transposed European legislation and national laws,regulations and administrative provisions). These requirements need also to be complied with, when and where they apply.NOTE 2 An informative database of European and national provisions on dangerous substances is available at theConstruction web site on EUROPA (CREATE, accessed through http://europa.eu.int/comm/enterprise/construction/internal/hygiene.htm )This annex ZA has the same scope, in relation to the products covered, as clause 1 of this standard. This annexestablishes the conditions for the CE marking of point heat detectors intended for the use shown below andidentifies the relevant clauses applicable.