Standard Svensk standard · SS-EN ISO 228-1

Whitworth rörgängor - Rörgängor för trycktäta förband med tätning utanför gängorna - Del 1: Basmått, toleranser och beteckning (ISO 228-1:2000)

Status: Gällande

Omfattning
This part of ISO 228 specifies the requirements for thread form, dimensions, tolerances and designation for fastening pipe threads, thread sizes 1/16 to 6 inclusive. Both internal and external threads are parallel threads, intended for the mechanical assembly of the component parts of fittings, cocks and valves, accessories, etc.

These threads are not suitable as jointing threads where a pressure-tight joint is made on the thread. If assemblies with such threads must be made pressure-tight, this should be effected by compressing two tightening surfaces outside the threads, and by interposing an appropriate seal.

NOTE1 For pipe threads where pressure-tight joints are made on the threads, see ISO 7-1.

NOTE2 ISO 228-2 gives details of methods for verification of fastening thread dimensions and form, and recommended gauging systems.

Ämnesområden

Specialgängor


Produktinformation

Språk: Engelska

Framtagen av: Fästelement, SIS/TK 103

Internationell titel: Pipe threads where pressure-tight joints are not made on the threads - Part 1: Dimensions, tolerances and designation (ISO 228-1:2000)

Artikelnummer: STD-34815

Utgåva: 1

Fastställd: 2003-11-07

Antal sidor: 20

Ersätter: SS-ISO 228-1