Standard Swedish standard · SS-EN 755-9

Aluminium and aluminium alloys - Extruded rod/bar, tube and profiles - Part 9: Profiles, tolerances on dimensions and form

Status: Withdrawn · Replaced by: SS-EN 755-9:2008

Scope
This part of EN 755 specifies the tolerances on dimensions and form for aluminium and aluminium alloy extruded profile with a cross section contained within a circumscribing circle not greater than 800 mm (see Figure 1). This standard applies to extruded profiles for general engineering applications only. The tolerances in this standard only apply to those dimensions that can be physically measured. NOTE Some of the products listed in the present standard can be subject to patent or patent applications, and their listing herein does not in any way imply the granting of a licence under such patent right. CEN/TC 132 affirms it is its policy that in the case when a patentee refuses to grant licences on standardised standard products under reasonable and not discriminatory conditions, then this product shall be removed from the corresponding standard.

Subjects

Aluminium products (77.150.10)


Product information

Language: Swedish

Written by: SIS - Materialteknik

International title:

Article no: STD-33723

Edition: 1

Approved: 10/19/2001

No of pages: 19

Also available in: SS-EN 755-9

Replaced by: SS-EN 755-9:2008