Standard Swedish standard · SS-ISO 13012-1:2019

Rolling bearings - Accessories for sleeve type linear ball bearings - Part 1: Boundary dimensions, geometrical product specifications (GPS) and tolerances for series 1 and 3 (ISO 13012-1:2018, IDT)

Status: Valid

Scope
This document specifies the boundary dimensions, other relevant dimensions and the corresponding tolerances of accessories for sleeve type linear ball bearings which are specified in ISO 10285. This document applies to: — the following housings: — closed and adjustable flangeless housings for series 1 sleeve type linear ball bearings, — closed and adjustable flanged housings for series 3 sleeve type linear ball bearings, — open flanged housings for series 3 sleeve type linear ball bearings, — closed and adjustable flangeless housings for series 3 sleeve type linear ball bearings, — open and open adjustable flangeless housings for series 3 sleeve type linear ball bearings; — the following shaft support rails: — standard height shaft support rails for series 3 sleeve type linear ball bearings, — low height shaft support rails for series 3 sleeve type linear ball bearings; — the following shaft support blocks: — flanged shaft support blocks for series 1 and 3 sleeve type linear ball bearings, — flangeless shaft support blocks for series 1 and 3 sleeve type linear ball bearings; — solid and tubular shafts for series 1 and 3 sleeve type linear ball bearings.

Subjects

Rolling bearings (21.100.20)


Product information

Language: English

Written by: SIS - Industriteknik

International title:

Article no: STD-80009361

Edition: 2

Approved: 1/18/2019

No of pages: 40

Replaces: SS-ISO 13012-1:2017