1. Start

Standard Swedish standard · SS-EN ISO 11363-1:2018

Gas cylinders - 17E and 25E taper threads for connection of valves to gas cylinders - Part 1: Specifications (ISO 11363-1:2018)

Status: Valid

Tell a colleague about

Scope
ISO 11363-1:2018 specifies dimensions and tolerances for taper screw threads of nominal diameter 17,4 mm (designated as 17E) and 25,8 mm (designated as 25E) used for the connection of valves to gas cylinders. ISO 11363-1:2018 does not cover the connection requirements for - mechanical strength, - gas tightness, and - capability of repeated assembly and dismounting operations. Gauge inspection is covered by ISO 11363-2.

Subjects

Unfired pressure vessels

Product information

Language: English

Written by: SIS - Materialteknik

International title: Gas cylinders - 17E and 25E taper threads for connection of valves to gas cylinders - Part 1: Specifications (ISO 11363-1:2018)

Article no: STD-80001492

Edition: 2

Approved: 2/26/2018

No of pages: 24

Replaces: SS-EN ISO 11363-1:2010/AC:2012 , SS-EN ISO 11363-1:2010

Related

Standards
SS-EN 13385 Transportable gas cylinders - Battery vehicles for permanent and liquefied gases (excluding acetylene) - Inspection at time of filling
SS-EN ISO 21007-1:2005 Gas cylinders - Identification and marking using radio frequency identification technology - Part 1: Reference architecture and terminology (ISO 21007-1:2005)
SS-EN ISO 11621:2005 Gas cylinders - Procedures for change of gas service (ISO 11621:1997)
Swedish Institute for Standards
Box 45443, SE-104 31 Stockholm
Sweden
+46 8-555 520 00
info@sis.se

Visiting address: Solnavägen 1E, 113 65 Stockholm.
LinkedIn
Copyright Disclaimer
Report error on page