21294 träffar på

Standard · ASTM ASTM E389

Standard Test Method for Particle Size or Screen Analysis at No. 4 (4.75-mm) Sieve and Coarser for Metal-Bearing Ores and Related Materials

1.1 This test method covers the determination of the size distribution by screen analysis of metal-bearing ores and related materials at No. 4 (4.75-mm) sieve and coarser.1.2 This standard does not...

Språk

Publicerad

2008-09-01

PDF · 468 SEK

Standard · ASTM ASTM A313/A313M

Standard Specification for Stainless Steel Spring Wire

Språk

Publicerad

2003-05-10

Upphävd

2008-10-01

PDF · 533 SEK

Standard · ASTM ASTM D3492

Standard Specification for Rubber Contraceptives (Male Condoms)

1.1 This specification covers the minimum requirements for individually packaged male condoms made from natural rubber latex and intended for single use. This specification does not cover the speci...

Språk

Publicerad

2003-08-10

Upphävd

2008-06-01

PDF · 611 SEK

Standard · ASTM ASTM D4395

Standard Test Method for Determining the In Situ Modulus of Deformation of Rock Mass Using the Flexible Plate Loading Method

1.1 This test method covers the preparation, equipment, test procedure, and data reduction for determining in situ modulus of deformation of a rock mass using the flexible plate loading method.1.2 ...

Språk

Publicerad

2004-01-01

Upphävd

2008-07-01

PDF · 533 SEK

Standard · ASTM ASTM D4435

Standard Test Method for Rock Bolt Anchor Pull Test 1

Språk

Publicerad

2004-01-01

Upphävd

2008-07-01

PDF · 533 SEK

Standard · ASTM ASTM D4436

Standard Test Method for Rock Bolt Long-Term Load Retention Test

1.1 The objective of this test method is to determine the time over which rock bolt tension decreases from the installed value to a designated minimum value.1.2 This test method is applicable to an...

Språk

Publicerad

2004-07-01

Upphävd

2008-07-01

PDF · 533 SEK

Standard · ASTM ASTM D4506

Standard Test Method for Determining the In Situ Modulus of Deformation of Rock Mass Using a Radial Jacking Test

1.1 This test method is used to determine the in situ modulus of deformation of rock mass by subjecting a test chamber of circular cross section to uniformly distributed radial loading; the consequ...

Språk

Publicerad

2006-05-01

Upphävd

2008-07-01

PDF · 533 SEK

Standard · ASTM ASTM D4525

Standard Test Method for Permeability of Rocks by Flowing Air

1.1 This test method covers the determination of the coefficient of specific permeability for the flow of air through rocks. The procedure is to establish representative values of the coefficient o...

Språk

Publicerad

2004-07-01

Upphävd

2008-07-01

PDF · 533 SEK

Standard · ASTM ASTM E1254

Standard Guide for Storage of Radiographs and Unexposed Industrial Radiographic Films

1.1 This guide may be used for the control and maintenance of industrial radiographs and unexposed films used for industrial radiography.1.2 The values stated in inch-pound units are to be regarded...

Språk

Publicerad

2003-07-10

Upphävd

2008-07-01

PDF · 468 SEK

Standard · ASTM ASTM E1817

Standard Practice for Controlling Quality of Radiological Examination by Using Representative Quality Indicators (RQIs)

1.1 This practice covers the radiological examination of unique materials or processes, or both, for which conventionally designed image quality indicators (IQIs), such as those described in Practi...

Språk

Publicerad

2003-03-10

Upphävd

2008-07-01

PDF · 468 SEK

Standard · ASTM ASTM E1901

Standard Guide for Detection and Evaluation of Discontinuities by Contact Pulse-Echo Straight-Beam Ultrasonic Methods

1.1 This guide covers procedures for the contact ultrasonic examination of bulk materials or parts by transmitting pulsed ultrasonic waves into the material and observing the indications of reflect...

Språk

Publicerad

2003-07-10

Upphävd

2008-07-01

PDF · 533 SEK

Standard · ASTM ASTM F837

Standard Specification for Stainless Steel Socket Head Cap Screws

1.1 This specification covers the chemical and mechanical requirements for stainless steel inch socket head cap screw (SHCS) with nominal thread 0.060 through 1.500 in. and intended for use in appl...

Språk

Publicerad

2002-07-10

Upphävd

2008-07-01

PDF · 533 SEK

Standard · ASTM ASTM A788/A788M

Standard Specification for Steel Forgings, General Requirements

1.1 This specification covers a group of common requirements that, unless otherwise specified in the individual product specification, shall apply to steel forgings under any of the following speci...

Språk

Publicerad

2006-09-01

Upphävd

2008-11-01

PDF · 611 SEK

Standard · ASTM ASTM D2332

Standard Practice for Analysis of Water-Formed Deposits by Wavelength-Dispersive X-Ray Fluorescence

1.1 This practice covers X-ray spectrochemical analysis of water-formed deposits.1.2 The practice is applicable to the determination of elements of atomic number 11 or higher that are present in si...

Språk

Publicerad

1984-12-28

Upphävd

2008-10-01

PDF · 468 SEK

Standard · ASTM ASTM D3858

Standard Test Method for Open-Channel Flow Measurement of Water by Velocity-Area Method

1.1 This test method covers the measurement of the volume rate of flow of water in open channels by determining the flow velocity and cross-sectional area and computing the discharge therefrom (Ref...

Språk

Publicerad

2008-10-01

PDF · 533 SEK

Standard · ASTM ASTM D3875

Standard Test Method for Alkalinity in Brackish Water, Seawater, and Brines

1.1 This test method covers the determination of alkalinity in brackish water, seawater, and brines.1.2 This standard does not purport to address all of the safety concerns, if any, associated with...

Språk

Publicerad

2003-08-10

Upphävd

2008-10-01

PDF · 468 SEK

Standard · ASTM ASTM D3975

Standard Practice for Development and Use (Preparation) of Samples for Collaborative Testing of Methods for Analysis of Sediments

1.1 This practice establishes uniform general procedures for the development, (preparation) and use of samples in the collaborative testing of methods for chemical analysis of sediments and similar...

Språk

Publicerad

2008-10-01

PDF · 533 SEK

Standard · ASTM ASTM D4190

Standard Test Method for Elements in Water by Direct-Current Argon Plasma Atomic Emission Spectroscopy

1.1 This test method covers the determination of dissolved and total recoverable elements in water, which includes drinking water, lake water, river water, sea water, snow, and Type II reagent wate...

Språk

Publicerad

2003-08-10

Upphävd

2008-10-01

PDF · 533 SEK

Standard · ASTM ASTM D4192

Standard Test Method for Potassium in Water by Atomic Absorption Spectrophotometry

1.1 This test method covers the determination of low amounts of potassium in waters having low solids content. The applicable range of this test method is 0.20 to 4.0 mg/L when using the 766.5-nm ...

Språk

Publicerad

2003-01-10

Upphävd

2008-10-01

PDF · 468 SEK

Standard · ASTM ASTM D4409

Standard Test Method for Velocity Measurements of Water in Open Channels with Rotating Element Current Meters

1.1 This test method describes the design and use of cup-type or vane-type vertical axis current meters and propeller-type horizontal axis current meters for measuring water velocities in open chan...

Språk

Publicerad

2008-10-01

PDF · 533 SEK

Standard · ASTM ASTM D4411

Standard Guide for Sampling Fluvial Sediment in Motion

1.1 This guide covers the equipment and basic procedures for sampling to determine discharge of sediment transported by moving liquids. Equipment and procedures were originally developed to sample ...

Språk

Publicerad

2008-10-01

PDF · 611 SEK

Standard · ASTM ASTM D4546

Standard Test Methods for One-Dimensional Swell or Settlement Potential of Cohesive Soils

1.1 These test methods cover three alternative laboratory methods for determining the magnitude of swell or settlement of relatively undisturbed or compacted cohesive soil. Note 1—Refer...

Språk

Publicerad

2003-01-10

Upphävd

2008-10-01

PDF · 533 SEK

Standard · ASTM ASTM D4822

Standard Guide for Selection of Methods of Particle Size Analysis of Fluvial Sediments (Manual Methods)

1.1 This guide covers the selection of methods for determining the size distribution of fluvial sediments particles in the range greater than 0.45 μm using manual methods. Manual methods a...

Språk

Publicerad

2008-10-01

PDF · 468 SEK

Standard · ASTM ASTM D4823

Standard Guide for Core Sampling Submerged, Unconsolidated Sediments

1.1 This guide covers core-sampling terminology, advantages and disadvantages of different types of core samplers, core-distortions that may occur during sampling, techniques for detecting and mini...

Språk

Publicerad

2008-10-01

PDF · 611 SEK

Standard · ASTM ASTM D5074

Standard Practice for Preparation of Natural-Matrix Sediment Reference Samples for Major and Trace Inorganic Constituents Analysis by Partial Extra...

1.1 This practice covers uniform procedures to develop, select, collect, prepare, and use oxidized, relatively unpolluted, aquatic natural-matrix bed-sediment reference samples for the collaborativ...

Språk

Publicerad

2008-10-01

PDF · 468 SEK

Standard · ASTM ASTM D5089

Standard Test Method for Velocity Measurements of Water in Open Channels with Electromagnetic Current Meters

1.1 This test method covers the use of single-axis or dual-axis electromagnetic current meters for the measurement of water velocities in open channels.1.2 This test method covers only these compon...

Språk

Publicerad

2008-10-01

PDF · 468 SEK

Standard · ASTM ASTM D5129

Standard Test Method for Open Channel Flow Measurement of Water Indirectly by Using Width Contractions

1.1 This test method covers the computation of discharge (the volume rate of flow) of water in open channels or streams using bridges that cause width contractions as metering devices.1.2 This test...

Språk

Publicerad

2008-10-01

PDF · 858 SEK

Standard · ASTM ASTM D5130

Standard Test Method for Open-Channel Flow Measurement of Water Indirectly by Slope-Area Method

1.1 This test method covers the computation of discharge (the volume rate of flow) of water in open channels or streams using representative cross-sectional characteristics, the water-surface slope...

Språk

Publicerad

2008-10-01

PDF · 611 SEK

Standard · ASTM ASTM D5463

Standard Guide for Use of Test Kits to Measure Inorganic Constituents in Water

1.1 This guide covers general considerations for the use of test kits for quantitative determination of analytes in water and wastewater. Test kits are available from various manufacturers for the ...

Språk

Publicerad

2003-06-10

Upphävd

2008-10-01

PDF · 533 SEK

Standard · ASTM ASTM D5540

Standard Practice for Flow Control and Temperature Control for On-Line Water Sampling and Analysis

1.1 This practice covers the conditioning of a flowing water sample for the precise measurement of various chemical and physical parameters of the water, whether continuous or grab. This practice a...

Språk

Publicerad

1994-09-15

Upphävd

2008-10-01

PDF · 468 SEK

Förfina din sökning genom att visa:

...som handlar om: