21331 träffar på

Standard · ASTM ASTM E549

Standard Guide for Preparing Field Sprayer Calibration Procedures

1.1 This guide is for those who prepare field sprayer calibration procedures. The purpose is to encourage methods that will improve uniformity, accuracy, and safety of pesticide application with fi...

Språk

Publicerad

2008-10-01

PDF · 468 SEK
Standard · ASTM ASTM E550

Standard Guide for Preparing Granular Pesticide Ground Applicator Calibration Procedures

1.1 This guide is for those who prepare granular pesticide ground applicator calibration procedures. The purpose is to encourage methods that will improve uniformity and accuracy of application wit...

Språk

Publicerad

2008-10-01

PDF · 468 SEK
Standard · ASTM ASTM E642

Standard Practice for Determining Application Rates and Distribution Patterns from Aerial Application Equipment

1.1 This practice covers uniform procedures for determining and reporting application rates and distribution patterns from agricultural aircraft. This practice should not be used for making biologi...

Språk

Publicerad

2008-10-01

PDF · 533 SEK
Standard · ASTM ASTM E1116

Standard Test Method for Emulsification Characteristics of Pesticide Emulsifiable Concentrates

1.1 This test method describes a general procedure for the determination of emulsification spontaneity and the emulsion stability characteristics of pesticide emulsifiable concentrates when diluted...

Språk

Publicerad

2008-10-01

PDF · 468 SEK
Standard · ASTM ASTM E1894

Standard Guide for Selecting Dosimetry Systems for Application in Pulsed X-Ray Sources

1.1 This guide provides assistance in selecting and using dosimetry systems in flash x-ray experiments. Both dose and dose-rate techniques are described.1.2 Operating characteristics of flash x-ray...

Språk

Publicerad

1997-06-10

Upphävd

2008-09-15

PDF · 611 SEK
Standard · ASTM ASTM E1945

Standard Test Method for Percent Dispersibility

1.1 This test method is used to determine the percent dispersibility of dry pesticide formulations.1.2 This standard does not purport to address all of the safety concerns, if any, associated with ...

Språk

Publicerad

2008-10-01

PDF · 468 SEK
Standard · ASTM ASTM E2190

Standard Specification for Insulating Glass Unit Performance and Evaluation

1.1 This specification is applicable to preassembled permanently sealed insulating glass units with one or two airspaces and preassembled insulating glass units with capillary tubes intentionally l...

Språk

Publicerad

2002-03-10

Upphävd

2008-10-15

PDF · 468 SEK
Standard · ASTM ASTM F1308

Standard Test Method for Quantitating Volatile Extractables in Microwave Susceptors Used for Food Products

1.1 This test method covers complete microwave susceptors.1.2 This test method covers a procedure for quantitating volatile compounds whose identity has been established and which are evolved when ...

Språk

Publicerad

2008-10-01

PDF · 533 SEK
Standard · ASTM ASTM F1416

Standard Guide for Selection of Time-Temperature Indicators

1.1 This guide covers information on the selection of commercially available time-temperature indicators (TTIs) for noninvasive external package use on perishable products, such as food and pharmac...

Språk

Publicerad

2008-10-01

PDF · 468 SEK
Standard · ASTM ASTM F1500

Standard Test Method for Quantitating Non-UV-Absorbing Nonvolatile Extractables from Microwave Susceptors Utilizing Solvents as Food Simulants

1.1 This test method is applicable to complete microwave susceptors.1.2 This test method covers a procedure for quantitating non-UV-absorbing nonvolatile compounds which are extractable when the mi...

Språk

Publicerad

2008-10-01

PDF · 468 SEK
Standard · ASTM ASTM F1519

Standard Test Method for Qualitative Analysis of Volatile Extractables in Microwave Susceptors Used to Heat Food Products

1.1 This test method is applicable to complete microwave susceptors.1.2 This test method covers a procedure for identifying volatile extractables which are released when a microwave susceptor sampl...

Språk

Publicerad

2008-10-01

PDF · 533 SEK
Standard · ASTM ASTM A377

Standard Index of Specifications for Ductile-Iron Pressure Pipe

1.1 This index identifies specifications that cover ductile-iron pressure pipe suitable for carrying water and other liquids under pressure.Note 1—The text of this standard references not...

Språk

Publicerad

2008-10-01

PDF · 468 SEK
Standard · ASTM ASTM F2607

Standard Test Method for Measuring the Hard Surface Floor-Cleaning Ability of Household/Commercial Vacuum Cleaners

1.1 This test method provides only a laboratory test for determining the relative hard surface floor-cleaning ability of household/commercial vacuum cleaners when tested under specified test condit...

Språk

Publicerad

2007-01-11

Upphävd

2008-10-15

PDF · 533 SEK
Standard · ASTM ASTM E203

Standard Test Method for Water Using Volumetric Karl Fischer Titration

-

Språk

Publicerad

2001-01-01

Upphävd

2008-10-01

PDF · 533 SEK
Standard · ASTM ASTM C592

Standard Specification for Mineral Fiber Blanket Insulation and Blanket-Type Pipe Insulation (Metal-Mesh Covered) (Industrial Type)

1.1 This specification covers the composition, dimensions, and physical properties of metal-mesh covered mineral fiber (rock, slag, or glass) blanket and blanket-type pipe insulation (typically on ...

Språk

Publicerad

2004-05-01

Upphävd

2008-10-01

PDF · 533 SEK
Standard · ASTM ASTM E275

Standard Practice for Describing and Measuring Performance of Ultraviolet, Visible, and Near-Infrared Spectrophotometers

1.1 This practice covers the description of requirements of spectrophotometric performance especially for ASTM methods, and the testing of the adequacy of available equipment for a specific method....

Språk

Publicerad

2001-02-10

Upphävd

2008-10-15

PDF · 533 SEK
Standard · ASTM ASTM C270

Standard Specification for Mortar for Unit Masonry

1.1 This specification covers mortars for use in the construction of non-reinforced and reinforced unit masonry structures. Four types of mortar are covered in each of two alternative specification...

Språk

Publicerad

2007-02-01

Upphävd

2008-08-01

PDF · 611 SEK
Standard · ASTM ASTM D1253

Standard Test Method for Residual Chlorine in Water

1.1 This test method covers the determination of residual chlorine in water by direct amperometric titration.1.2 Within the constraints specified in Section 6, this test method is not subject to co...

Språk

Publicerad

2003-06-10

Upphävd

2008-10-01

PDF · 533 SEK
Standard · ASTM ASTM D7482

Standard Practice for Sampling, Storage, and Handling of Hydrocarbons for Mercury Analysis

1.1 This practice covers the types of and preparation of containers found most suitable for the handling of hydrocarbon samples for the determination of total mercury. 1.2 This practice was devel...

Språk

Publicerad

2008-10-15

PDF · 468 SEK
Standard · ASTM ASTM E2655

Standard Guide for Reporting Uncertainty of Test Results and Use of the Term Measurement Uncertainty in ASTM Test Methods

1.1 This guide provides concepts necessary for understanding the term “uncertainty” when applied to a quantitative test result. Several measures of uncertainty can be applied ...

Språk

Publicerad

2008-10-01

PDF · 533 SEK
Standard · ASTM ASTM F2129

Standard Test Method for Conducting Cyclic Potentiodynamic Polarization Measurements to Determine the Corrosion Susceptibility of Small Implant Dev...

1.1 This test method assesses the corrosion susceptibility of small, metallic, implant medical devices, or components thereof, using cyclic (forward and reverse) potentiodynamic polarization. Exa...

Språk

Publicerad

2008-10-01

PDF · 533 SEK
Standard · ASTM ASTM D6210

Standard Specification for Fully-Formulated Glycol Base Engine Coolant for Heavy-Duty Engines

-

Språk

Publicerad

2006-01-01

Upphävd

2008-10-01

PDF · 468 SEK
Standard · ASTM ASTM E178

Standard Practice for Dealing With Outlying Observations

1.1 This practice covers outlying observations in samples and how to test the statistical significance of them. An outlying observation, or "outlier," is one that appears to deviate markedly from o...

Språk

Publicerad

2002-05-10

Upphävd

2008-10-01

PDF · 611 SEK
Standard · ASTM ASTM C503

Standard Specification for Marble Dimension Stone

1.1 This specification covers the material characteristics, physical requirements, and sampling appropriate to the selection of marble for general building and structural purposes. Refer to Guides ...

Språk

Publicerad

2008-04-09

Upphävd

2008-10-01

PDF · 468 SEK
Standard · ASTM ASTM D2318

Standard Test Method for Quinoline-Insoluble (QI) Content of Tar and Pitch

1.1 This test method covers the determination of the quinoline-insoluble matter (QI) in tar and pitch.1.2 Since this test method is empirical, strict adherence to all details of the procedure is ne...

Språk

Publicerad

2008-10-15

PDF · 468 SEK
Standard · ASTM ASTM D2570

Standard Test Method for Simulated Service Corrosion Testing of Engine Coolants

-

Språk

Publicerad

2002-06-01

Upphävd

2008-10-01

PDF · 533 SEK
Standard · ASTM ASTM D3585

Standard Specification for ASTM Reference Fluid for Coolant Tests

1.1 This specification covers a reference ethylene glycol-base test fluid to be used in providing base line data for ASTM coolant test procedures.This standard does not purport to address all of th...

Språk

Publicerad

1998-04-10

Upphävd

2008-10-01

PDF · 533 SEK
Standard · ASTM ASTM D4072

Standard Test Method for Toluene-Insoluble (TI) Content of Tar and Pitch

1.1 This test method covers the determination of toluene-insoluble matter (TI) in tar and pitch. 1.2 Since this test method is empirical, strict adherence to all details of the procedure is neces...

Språk

Publicerad

2008-10-15

PDF · 468 SEK
Standard · ASTM ASTM D4422

Standard Test Method for Ash in Analysis of Petroleum Coke

1.1 This test method covers the determination of the ash content of petroleum coke.1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for info...

Språk

Publicerad

2008-10-15

PDF · 468 SEK
Standard · ASTM ASTM D4742

Standard Test Method for Oxidation Stability of Gasoline Automotive Engine Oils by Thin-Film Oxygen Uptake (TFOUT)

1.1 This test method evaluates the oxidation stability of engine oils for gasoline automotive engines. This test, run at 160°C, utilizes a high pressure reactor pressurized with oxygen alo...

Språk

Publicerad

2002-04-10

Upphävd

2008-10-15

PDF · 533 SEK
Visa varukorgen Fortsätt handla 0
Varukorgen Stäng
Annonstext