21289 träffar på

Standard · ASTM ASTM D4615

Standard Specification for n-Butyl Acetate (All Grades)

1.1 This specification covers the various grades of n-butyl acetate suitable for use as solvents in paint and related coatings.1.2 The following applies to all specified limits in this standard; fo...

Språk

Publicerad

2006-06-01

Upphävd

2012-11-01

PDF · 468 SEK

Standard · ASTM ASTM D4647

Standard Test Method for Identification and Classification of Dispersive Clay Soils by the Pinhole Test

1.1 This test method presents a direct, qualitative measurement of the dispersibility and consequent colloidal erodibility of clay soils by causing water to flow through a small hole punched in a s...

Språk

Publicerad

2006-11-01

Upphävd

2013-01-01

PDF · 611 SEK

Standard · ASTM ASTM D4806

Standard Specification for Denatured Fuel Ethanol for Blending with Gasolines for Use as Automotive Spark-Ignition Engine Fuel

1.1 This specification covers nominally anhydrous denatured fuel ethanol intended to be blended with unleaded or leaded gasolines at 1 to 10 volume % for use as automotive spark-ignition engine fue...

Språk

Publicerad

2011-05-01

Upphävd

2012-12-01

PDF · 533 SEK

Standard · ASTM ASTM D2319/ D2319M

Standard Test Method for Softening Point of Pitch (Cube-in-Air Method)

1.1 This test method covers the determination of the softening point above 176°F (80°C) of pitch. Test Method D 3104 gives comparable results.1.2 The values stated in SI units are...

Språk

Publicerad

2003-11-01

PDF · 468 SEK

Standard · ASTM ASTM D4857

Standard Test Method for Determination of the Ability of Lubricants to Minimize Ring Sticking and Piston Deposits in Two-Stroke-Cycle Gasoline Engi...

1.1 This test method evaluates the performance of lubricants intended for use in two-stroke-cycle spark-ignition gasoline engines that are particularly prone to ring sticking. Piston varnish and s...

Språk

Publicerad

2008-12-01

Upphävd

2012-11-01

PDF · 533 SEK

Standard · ASTM ASTM D5133

Standard Test Method for Low Temperature, Low Shear Rate, Viscosity/Temperature Dependence of Lubricating Oils Using a Temperature-Scanning Technique

1.1 This test method covers the measurement of the apparent viscosity of engine oil at low temperatures. 1.2 A shear rate of approximately 0.2 s-1 is produced at shear stresses below 100 Pa. Appare...

Språk

Publicerad

2005-04-01

Upphävd

2012-12-01

PDF · 611 SEK

Standard · ASTM ASTM D2622

Standard Test Method for Sulfur in Petroleum Products by Wavelength Dispersive X-ray Fluorescence Spectrometry

1.1 This test method covers the determination of total sulfur in petroleum and petroleum products that are single-phase and either liquid at ambient conditions, liquefiable with moderate heat, or s...

Språk

Publicerad

2007-09-05

Upphävd

2008-03-01

PDF · 611 SEK

Standard · ASTM ASTM D2622

Standard Test Method for Sulfur in Petroleum Products by Wavelength Dispersive X-ray Fluorescence Spectrometry

Språk

Publicerad

2008-04-09

Upphävd

2010-02-15

PDF · 611 SEK

Standard · ASTM ASTM D5430

Standard Test Methods for Visually Inspecting and Grading Fabrics

1.1 These test methods describe a procedure to establish a numerical designation for grading of fabrics from a visual inspection. 1.2 These test methods may be used for the delivery and acceptance ...

Språk

Publicerad

2008-03-12

Upphävd

2013-01-01

PDF · 468 SEK

Standard · ASTM ASTM D5478

Standard Test Methods for Viscosity of Materials by a Falling Needle Viscometer

1.1 These test methods cover the measurement of the viscosity of Newtonian and non-Newtonian liquids. These test methods are applicable to liquids having viscosities in the range from 5 &#x0...

Språk

Publicerad

2009-02-01

Upphävd

2013-02-01

PDF · 533 SEK

Standard · ASTM ASTM D5646

Standard Terminology of Basic Sewing Machine Stitches for Home Use

1.1 This terminology covers basic stitches made by sewing machines designed for home use and provides a uniform, easily understood language for the definitions and descriptions of seams and seam fi...

Språk

Publicerad

2011-05-20

Upphävd

2013-01-01

PDF · 533 SEK

Standard · ASTM ASTM D5681

Standard Terminology for Waste and Waste Management

1.1 This terminology contains standard definitions of terms used in the general area of waste and waste management. It is intended to promote understanding by providing precise technical definition...

Språk

Publicerad

2009-07-01

Upphävd

2013-02-01

PDF · 611 SEK

Standard · ASTM ASTM D975

Standard Specification for Diesel Fuel Oils

1.1 This specification covers seven grades of diesel fuel oils suitable for various types of diesel engines. These grades are described as follows: 1.1.1 Grade No. 1-D S15& This specification c...

Språk

Publicerad

2008-06-04

Upphävd

2009-07-01

PDF · 767 SEK

Standard · ASTM ASTM D2982

Standard Test Methods for Detecting Glycol-Base Antifreeze in Used Lubricating Oils

1.1 These test methods describe the qualitative determination of glycol-base antifreeze in used lubricating oils (mineral base) by two procedures, one using reagents in tablet form and the other us...

Språk

Publicerad

2004-12-01

Upphävd

2007-01-01

PDF · 533 SEK

Standard · ASTM ASTM D3348

Standard Test Method for Rapid Field Test for Trace Lead in Unleaded Gasoline (Colorimetric Method)

1.1 This test method covers and is intended for use in the field by nontechnical people for the quantitative measurement of lead in unleaded gasoline in the range from 0.01 to 0.10 g Pb/U.S. gal ...

Språk

Publicerad

2008-03-12

Upphävd

2012-02-01

PDF · 533 SEK

Standard · ASTM ASTM D3522

Standard Test Method for Applied Coating Wax and Impregnating (Saturating) Wax in Corrugated Board Facing

1.1 This test method covers the determination of the weight of wax that has been applied for coating of corrugated board, and the amount of impregnating (saturating) wax in the same facing.1.2 This...

Språk

Publicerad

2007-09-05

Upphävd

2012-01-01

PDF · 468 SEK

Standard · ASTM ASTM D5708

Standard Test Methods for Determination of Nickel, Vanadium, and Iron in Crude Oils and Residual Fuels by Inductively Coupled Plasma (ICP) Atomic E...

1.1 These test methods cover the determination of nickel, vanadium, and iron in crude oils and residual fuels by inductively coupled plasma (ICP) atomic emission spectrometry. Two different test me...

Språk

Publicerad

2011-09-16

Upphävd

2012-12-01

PDF · 533 SEK

Standard · ASTM ASTM D5798

Standard Specification for Ethanol Fuel Blends for Flexible-Fuel Automotive Spark-Ignition Engines

1.1 This specification covers the requirements for automotive fuel blends of ethanol and gasoline for use in ground vehicles equipped with flexible-fuel spark-ignition engines. Fuel produced to thi...

Språk

Publicerad

2011-09-16

Upphävd

2012-12-01

PDF · 533 SEK

Standard · ASTM ASTM D5822

Standard Test Method for Determining Seam Strength in Inflatable Restraint Cushions

1.1 This test method covers the measurement of seam efficiency and the maximum seam strength in inflatable restraint cushions composed of woven fabrics when a force is applied perpendicular to the ...

Språk

Publicerad

2008-09-03

Upphävd

2013-01-01

PDF · 533 SEK

Standard · ASTM ASTM D5866

Standard Test Method for Neps in Cotton Fibers (AFIS-N Instrument)

1.1 This test method covers the quantity and size of neps in cotton using the AFIS-N instrument.1.2 This test method is intended primarily for testing raw and processed cotton fibers.1.3 The values...

Språk

Publicerad

2005-03-01

Upphävd

2012-12-01

PDF · 468 SEK

Standard · ASTM ASTM D5900

Standard Specification for Physical and Chemical Properties of Industry Reference Materials (IRM)

1.1 This specification covers the chemical and physical quality specifications or requirements, or both, for Industry Reference Materials (IRMs) as cited in Practice D 4678 and other standards. 1.2...

Språk

Publicerad

2008-11-05

Upphävd

2010-07-01

PDF · 533 SEK

Standard · ASTM ASTM D6045

Standard Test Method for Color of Petroleum Products by the Automatic Tristimulus Method

1.1 This test method covers the automatic determination of color of a wide variety of petroleum products such as undyed motor and aviation gasoline, aviation turbine fuels, naphthas, kerosine, phar...

Språk

Publicerad

2009-12-01

Upphävd

2012-12-01

PDF · 533 SEK

Standard · ASTM ASTM D6204

Standard Test Method for Rubber-Measurement of Unvulcanized Rheological Properties Using Rotorless Shear Rheometers

1.1 This test method covers the use of a rotorless oscillating shear rheometer for the measurement of the flow properties of raw rubber and unvulcanized rubber compounds. These flow properties are ...

Språk

Publicerad

2007-09-05

Upphävd

2012-12-15

PDF · 533 SEK

Standard · ASTM ASTM D6601

Standard Test Method for Rubber Properties—Measurement of Cure and After-Cure Dynamic Properties Using a Rotorless Shear Rheometer

1.1 This test method covers the use of a rotorless oscillating shear rheometer for measuring after cure dynamic properties at predetermined temperature(s) below the cure temperature. 1.2 Specified ...

Språk

Publicerad

2008-05-01

Upphävd

2012-12-01

PDF · 468 SEK

Standard · ASTM ASTM D6608

Standard Practice for the Identification of Trinidad Lake Asphalt in Asphalt Mixes

1.1 This practice shall be used for the qualitative determination of Trinidad Lake Asphalt in Trinidad Lake Modified Asphalt Cements obtained from production blends or recovered binder from asphalt...

Språk

Publicerad

2006-06-01

Upphävd

2012-12-01

PDF · 468 SEK

Standard · ASTM ASTM D6653/D6653M

Standard Test Methods for Determining the Effects of High Altitude on Packaging Systems by Vacuum Method

1.1 These test methods determine the effects of pressure differential when packaged products are transported via certain modes of transport, such as feeder aircraft or ground over high mountain pas...

Språk

Publicerad

2007-01-11

Upphävd

2013-01-15

PDF · 468 SEK

Standard · ASTM ASTM D6799

Standard Terminology Relating to Inflatable Restraints

1.1 This standard covers terminology which is used in the evaluation of inflatable restraint fabrics, cushions, and modules.

Språk

Publicerad

2008-11-05

Upphävd

2013-01-01

PDF · 468 SEK

Standard · ASTM ASTM D6906

Standard Test Method for Determination of Titanium Treatment Weight on Metal Substrates by X-Ray Fluorescence

1.1 This test method covers the use of X-ray fluorescence (XRF) techniques for determination of the coating weight of titanium treatments on metal substrates. These techniques are applicable for de...

Språk

Publicerad

2003-05-10

Upphävd

2011-06-01

PDF · 468 SEK

Standard · ASTM ASTM D6906

Standard Test Method for Determination of Titanium Treatment Weight on Metal Substrates by Wavelength Dispersive X-Ray Fluorescence

1.1 This test method covers the use of wavelength dispersive X-ray fluorescence (WDXRF) techniques for determination of the coating weight of titanium treatments on metal substrates. These techniqu...

Språk

Publicerad

2011-03-18

Upphävd

2012-11-01

PDF · 468 SEK

Standard · ASTM ASTM D7108

Standard Guide for Establishing Qualifications for a Nuclear Coatings Specialist

1.1 This guide delineates recommendations for development of procedures and criteria for designation of personnel as a Nuclear Coatings Specialist involved in work in nuclear facilities. The Nuclea...

Språk

Publicerad

2005-09-01

Upphävd

2012-11-15

PDF · 468 SEK

Förfina din sökning genom att visa:

...som handlar om: