21328 träffar på

ASTM D5154
Standard · ASTM ASTM D5154

Standard Test Method for Determining Activity and Selectivity of Fluid Catalytic Cracking (FCC) Catalysts by Microactivity Test

1.1 This test method covers determining the activity and selectivity of either equilibrium or laboratory deactivated fluid catalytic cracking (FCC) catalysts. The activity is evaluated on the basis...

Språk

Publicerad

2010-05-17
PDF · 533 SEK
ASTM E313
Standard · ASTM ASTM E313

Standard Practice for Calculating Yellowness and Whiteness Indices from Instrumentally Measured Color Coordinates

1.1 This practice provides numbers that correlate with visual ratings of yellowness or whiteness of white and near-white or colorless object-color specimens, viewed in daylight by an observer with...

Språk

Publicerad

2010-09-17
PDF · 533 SEK
ASTM D635
Standard · ASTM ASTM D635

Standard Test Method for Rate of Burning and/or Extent and Time of Burning of Plastics in a Horizontal Position

1.1 This fire-test-response test method covers a small-scale laboratory screening procedure for comparing the relative linear rate of burning or extent and time of burning, or both, of plastics in ...

Språk

Publicerad

2010-07-01
PDF · 533 SEK
ASTM D4530
Standard · ASTM ASTM D4530

Standard Test Method for Determination of Carbon Residue (Micro Method)

1.1 This test method covers the determination of the amount of carbon residue (see Note 1) formed after evaporation and pyrolysis of petroleum materials under certain conditions and is intended t...

Språk

Publicerad

2011-09-16
PDF · 533 SEK
ASTM D6148
Standard · ASTM ASTM D6148

Standard Practice for Separation and Examination of Stickies (Withdrawn 2010)

1.1 This practice is applicable to a wide range of virgin pulps or pulps derived from recovered materials or recovered paper of the type typically used to produce paper, paperboard and other paper ...

Språk

Publicerad

1997-07-10

Upphävd

2010-08-01
PDF · 533 SEK
ASTM E1915
Standard · ASTM ASTM E1915

Standard Test Methods for Analysis of Metal Bearing Ores and Related Materials for Carbon, Sulfur, and Acid-Base Characteristics

1.1 These test methods cover the determination of total carbon and sulfur and acid-base characteristics in metal bearing ores and related materials such as leach residues, tailings, and waste ro...

Språk

Publicerad

2012-02-24
PDF · 767 SEK
ASTM F1994
Standard · ASTM ASTM F1994

Standard Test Method for Shipboard Fixed Foam Firefighting Systems

1.1 This test method covers shipboard, fixed (installed) foam/sprinkling firefighting systems. 1.2 Satisfactory completion of these tests indicates functional performance of the fixed foam firefigh...

Språk

Publicerad

2005-05-01
PDF · 533 SEK
ASTM E1069
Standard · ASTM ASTM E1069

Standard Test Method for Testing Polymeric Seal Materials for Geothermal and/or High Temperature Service Under Sealing Stress

1.1 This test method covers the initial evaluation of (screening) polymeric materials for seals under static sealing stress and at elevated temperatures. 1.2 This test method applies to geothermal ...

Språk

Publicerad

1985-05-31
PDF · 468 SEK
ASTM D5551
Standard · ASTM ASTM D5551

Standard Test Method for Determination of the Cloud Point of Oil

1.1 This test method covers the determination of the cloud point of oils used in the softening and stuffing of leather and in the manufacture of fat liquors and other softening and stuffing compoun...

Språk

Publicerad

2006-04-01
PDF · 468 SEK
ASTM F1661
Standard · ASTM ASTM F1661

Standard Test Method for Determining the Contact Bounce Time of a Membrane Switch

1.1 This test method covers the determination of the contact bounce time of a membrane switch. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are in...

Språk

Publicerad

2009-06-15
PDF · 468 SEK
ASTM E162
Standard · ASTM ASTM E162

Standard Test Method for Surface Flammability of Materials Using a Radiant Heat Energy Source

1.1 This fire-test-response standard describes the measurement of surface flammability of materials. It is not intended for use as a basis of ratings for building code purposes (see Appendix X1)....

Språk

Publicerad

2012-03-23
PDF · 611 SEK
ASTM F1962
Standard · ASTM ASTM F1962

Standard Guide for Use of Maxi-Horizontal Directional Drilling for Placement of Polyethylene Pipe or Conduit Under Obstacles, Including River Cross...

1.1 This guide describes the design, selection considerations, and installation procedures for the placement of polyethylene pipe or conduit below ground using maxi-horizontal directional drilling ...

Språk

Publicerad

2011-08-25
PDF · 611 SEK
ASTM E431
Standard · ASTM ASTM E431

Standard Guide to Interpretation of Radiographs of Semiconductors and Related Devices

1.1 This guide provides illustrations of radiographs of semiconductors and related devices. Low powered transistors (through the TO-11 case configuration), diodes, low-power rectifiers, power devic...

Språk

Publicerad

2007-08-08
PDF · 533 SEK
ASTM E133
Standard · ASTM ASTM E133

Standard Specification for Distillation Equipment

1.1 This specification covers distillation equipment used in the following ASTM test methods: D86, This specification covers distillation equipment. The equipment shall consist of the following: di...

Språk

Publicerad

2005-10-01
PDF · 468 SEK
ASTM A951/A951M
Standard · ASTM ASTM A951/A951M

Standard Specification for Steel Wire for Masonry Joint Reinforcement

1.1 This specification covers masonry joint reinforcement fabricated from cold-drawn steel wire. Joint reinforcement consists of longitudinal wires welded to cross wires. 1.2 The values stated in...

Språk

Publicerad

2011-12-16
PDF · 533 SEK
ASTM F2531
Standard · ASTM ASTM F2531

Standard Test Method for Load Capacity of Treestand Seats

1.1 This test method covers the determination of the static load capacity of treestand seats in terms of a factor of safety relative to the manufacturers rated capacity. 1.2 The values stated in ...

Språk

Publicerad

2005-10-01
PDF · 468 SEK
ASTM C118M
Standard · ASTM ASTM C118M

Standard Specification for Concrete Pipe for Irrigation or Drainage (Metric)

1.1 This specification covers nonreinforced concrete pipe to be used for the conveyance of irrigation water with working pressures, including hydraulic transients, as shown in Table 1 and for use...

Språk

Publicerad

2011-11-18
PDF · 468 SEK
ASTM D4913
Standard · ASTM ASTM D4913

Standard Practice for Determining Concentration of Hydrogen Sulfide by Direct Reading, Length of Stain, Visual Chemical Detectors

1.1 This practice covers the detection of hydrogen sulfide gas by visual chemical detectors. Included under visual chemical detectors are: short-term detector tubes (1), long-term detector tubes &...

Språk

Publicerad

2005-10-01
PDF · 468 SEK
ASTM D5850
Standard · ASTM ASTM D5850

Standard Test Method for (Analytical Procedure) Determining Transmissivity, Storage Coefficient, and Anisotropy Ratio from a Network of Partiall...

1.1 This test method covers an analytical procedure for determining the transmissivity, storage coefficient, and ratio of vertical to horizontal hydraulic conductivity of a confine

Språk

Publicerad

2006-09-15
PDF · 611 SEK
ASTM D1922
Standard · ASTM ASTM D1922

Standard Test Method for Propagation Tear Resistance of Plastic Film and Thin Sheeting by Pendulum Method

1.1 This test method covers the determination of the average force to propagate tearing through a specified length of plastic film or nonrigid sheeting after the tear has been started, using an El...

Språk

Publicerad

2009-05-01
PDF · 533 SEK
ASTM D524
Standard · ASTM ASTM D524

Standard Test Method for Ramsbottom Carbon Residue of Petroleum Products

1.1 This test method covers the determination of the amount of carbon residue (Note 1) left after evaporation and pyrolysis of an oil, and it is intended to provide some indication of relative co...

Språk

Publicerad

2010-09-17
PDF · 533 SEK
ASTM D1621
Standard · ASTM ASTM D1621

Standard Test Method for Compressive Properties Of Rigid Cellular Plastics

1.1 This test method describes a procedure for determining the compressive properties of rigid cellular materials, particularly expanded plastics. 1.2 The values stated in SI units are to be regard...

Språk

Publicerad

2010-06-18
PDF · 533 SEK
ASTM D6252/D6252M
Standard · ASTM ASTM D6252/D6252M

Standard Test Method for Peel Adhesion of Pressure-Sensitive Label Stocks at a 90&#176 Angle

1.1 This test method covers the measurement of the peel adhesion of pressure-sensitive label stocks. This test method gives a measure of the adherence to a standard steel substrate or to other surf...

Språk

Publicerad

1998-04-10
PDF · 468 SEK
ASTM D4620
Standard · ASTM ASTM D4620

Standard Test Method for Evaluating the Effective Surface Area of Zinc Oxide in Rubber

1.1 This test method specifies the standard materials, mixing procedure, and test method for ranking zinc-oxide samples according to their specific surface area in a standard test formula based on ...

Språk

Publicerad

2008-03-12
PDF · 468 SEK
ASTM F2573
Standard · ASTM ASTM F2573

Standard Specification for Low Velocity Resilient Material Projectile

1.1 This specification covers critical characteristics of low velocity resilient material projectiles (herein referred to as LVRM projectiles) made of a resilient material, and shall have a diamet...

Språk

Publicerad

2006-05-01
PDF · 468 SEK
ASTM E1960
Standard · ASTM ASTM E1960

Standard Practice for Calculating International Friction Index of a Pavement Surface

1.1 This practice covers the calculation of the International Friction Index (IFI) from a measurement of pavement macrotexture and wet pavement friction. The IFI was developed in the PIARC Intern...

Språk

Publicerad

2007-09-05
PDF · 533 SEK
ASTM F508
Standard · ASTM ASTM F508

Standard Practice for Specifying Thick-Film Pastes (Withdrawn 2008)

1.1 This practice covers the writing of specifications for thick-film pastes for electronics. 1.2 The practice provides a guide for the routine procedure to be followed in specifying for procurem...

Språk

Publicerad

2002-12-10

Upphävd

2008-07-30
PDF · 468 SEK
ASTM E2006
Standard · ASTM ASTM E2006

Standard Guide for Benchmark Testing of Light Water Reactor Calculations

1.1 This guide covers general approaches for benchmarking neutron transport calculations in light water reactor systems. A companion guide (Guide E2005

Språk

Publicerad

2011-05-20
PDF · 533 SEK
ASTM E2297
Standard · ASTM ASTM E2297

Standard Guide for Use of UV-A and Visible Light Sources and Meters used in the Liquid Penetrant and Magnetic Particle Methods

1.1 This guide describes the use of UV-A/Visible light sources and meters used for the examination of materials by the liquid penetrant and magnetic particle processes. This guide may be used to he...

Språk

Publicerad

2004-02-01
PDF · 533 SEK
ASTM E1018
Standard · ASTM ASTM E1018

Standard Guide for Application of ASTM Evaluated Cross Section Data File, Matrix E 706 (IIB)

1.1 This guide covers the establishment and use of an ASTM evaluated nuclear data cross section and uncertainty file for analysis of single or multiple sensor measurements in neutron fields related...

Språk

Publicerad

2009-06-01
PDF · 533 SEK
Förfina din sökning genom att visa:
...som handlar om:

Ämnesområden (0)

Avbryt

Branscher (0)

Avbryt

Syfte (0)

Avbryt

Material (0)

Avbryt
Visa varukorgen Fortsätt handla 0
Varukorgen Stäng
Annonstext