21313 träffar på

Standard · ASTM ASTM D473

Standard Test Method for Sediment in Crude Oils and Fuel Oils by the Extraction Method

1.1 This test method covers the determination of sediment in crude oils and fuel oils by extraction with toluene. The precision applies to a range of sediment levels from 0.01 to 0.40 % mass, altho...

Språk

Publicerad

2006-11-01

Upphävd

2007-05-01

PDF · 533 SEK

Standard · ASTM ASTM D4586

Standard Specification for Asphalt Roof Cement, Asbestos-Free

1.1 This specification covers asbestos-free asphalt roof cement suitable for trowel application to roofings and flashings.The following precautionary caveat pertains only to the test method portion...

Språk

Publicerad

2007-02-07

Upphävd

2007-05-01

PDF · 468 SEK

Standard · ASTM ASTM D5665

Standard Specification for Thermoplastic Fabrics Used in Cold-Applied Roofing and Waterproofing

1.1 This specification covers thermoplastic fabrics such as polyester, polyester/polyamide bicomponent, or composites with fiberglass or polyester scrims that can be used during the construction of...

Språk

Publicerad

2007-02-07

PDF · 468 SEK

Standard · ASTM ASTM D6369

Standard Guide for Design of Standard Flashing Details for EPDM Roof Membranes

p>1.1 This guide covers the design of details for typical conditions encountered in new ballasted, mechanically attached or fully adhered ethylene propylene diene terpolymer (EPDM) sheet roof sy...

Språk

Publicerad

2007-02-07

PDF · 611 SEK

Standard · ASTM ASTM E2340

Standard Test Method for Measuring the Skid Resistance of Pavements and Other Trafficked Surfaces Using a Continuous Reading, Fixed-Slip Technique

1.1 This test method covers the measurement of the skid resistance of a pavement or other trafficked surface using the continuous reading, fixed-slip technique.1.2 This test method covers braked wh...

Språk

Publicerad

2007-02-07

PDF · 533 SEK

Standard · ASTM ASTM E2529

Standard Guide for Testing the Resolution of a Raman Spectrometer

1.1 This guide is designed for routine testing and assessment of the spectral resolution of Raman spectrometers using either a low-pressure arc lamp emission lines or a calibrated Raman band of cal...

Språk

Publicerad

2007-02-07

PDF · 533 SEK

Standard · ASTM ASTM F17

Standard Terminology Relating to Flexible Barrier Materials

Språk

Publicerad

2007-02-07

Upphävd

2007-05-01

PDF · 468 SEK

Standard · ASTM ASTM F2594

Standard Guide for Unmanned Undersea Vehicle (UUV) Communications

1.1 This guide establishes the basic communications requirements for Unmanned Undersea Vehicles (UUVs). In its first instantiation, this guide serves as only a guideline, and not a definitive direc...

Språk

Publicerad

2006-09-01

Upphävd

2007-04-15

PDF · 767 SEK

Standard · ASTM ASTM F2595

Standard Guide for Unmanned Undersea Vehicle (UUV) Sensor Data Formats

1.1 This guide establishes the basic sensor data format requirements for Unmanned Undersea Vehicles (UUVs). This guide is intended to influence the development process for the acquisition and integ...

Språk

Publicerad

2006-07-01

Upphävd

2007-04-15

PDF · 611 SEK

Standard · ASTM ASTM A90/A90M

Standard Test Method for Weight [Mass] of Coating on Iron and Steel Articles with Zinc or Zinc-Alloy Coatings

1.1 This test method covers procedures for determining the weight [mass] of coating on iron or steel sheet, wire, and other articles in which the coating is zinc or a zinc alloy, such as zinc-5 % a...

Språk

Publicerad

2006-11-15

Upphävd

2007-05-01

PDF · 468 SEK

Standard · ASTM ASTM E1898

Standard Test Method for Determination of Silver in Copper Concentrates by Flame Atomic Absorption Spectrometry

1.1 This test method covers the determination of silver in the range of 50 g/g to 1000 g/g by acid dissolution of the silver and measurement by atomic absorption spectrophotometry. Copper concentra...

Språk

Publicerad

2002-05-10

Upphävd

2007-06-01

PDF · 533 SEK

Standard · ASTM ASTM C1386

Standard Specification for Precast Autoclaved Aerated Concrete (PAAC) Wall Construction Units

1.1 This specification covers solid nonload-bearing and load-bearing precast concrete wall units made from autoclaved aerated concrete (PAAC) is a cementitious product based on calcium silicate hyd...

Språk

Publicerad

1998-02-10

Upphävd

2007-03-12

PDF · 468 SEK

Standard · ASTM ASTM E1966

Standard Test Method for Fire-Resistive Joint Systems

1.1 This fire-test-response test method measures the performance of joint systems designed to be used with fire rated floors and walls during a fire endurance test exposure. The fire endurance test...

Språk

Publicerad

2001-10-10

Upphävd

2007-08-01

PDF · 611 SEK

Standard · ASTM ASTM D6251/D6251M

Standard Specification for Wood-Cleated Panelboard Shipping Boxes

1.1 This specification covers the fabrication and closure of empty and full wood-cleated, hereafter referred to as wood-cleated, panelboard boxes. These boxes are intended for use as containers for...

Språk

Publicerad

2001-10-10

Upphävd

2007-06-01

PDF · 611 SEK

Standard · ASTM ASTM E2079

Standard Test Methods for Limiting Oxygen (Oxidant) Concentration in Gases and Vapors

1.1 These test methods cover the determination of the limiting oxygen (oxidant) concentration of mixtures of oxygen (oxidant) and inert gases with flammable gases and vapors at a specified initial ...

Språk

Publicerad

2001-10-10

Upphävd

2007-01-01

PDF · 533 SEK

Standard · ASTM ASTM D6598

Standard Guide for Installing and Operating Settlement Platforms for Monitoring Vertical Deformations

1.1 This guide provides recommended designs and procedures for the fabrication, installation, operation, and reading of settlement platform to determine the magnitude and rate of foundation, fill s...

Språk

Publicerad

2000-11-10

Upphävd

2007-05-01

PDF · 533 SEK

Standard · ASTM ASTM F2119

Standard Test Method for Evaluation of MR Image Artifacts from Passive Implants

1.1 This test method characterizes the distortion and signal loss artifacts produced in a magnetic resonance (MR) image by a passive implant (implant that functions without the supply of electrical...

Språk

Publicerad

2001-06-10

Upphävd

2007-09-01

PDF · 468 SEK

Standard · ASTM ASTM F2180

Standard Specification for Metallic Implantable Strands and Cables

1.1 This specification covers the materials, dimensional tolerances, constructions, and mechanical properties for standard metallic implantable strands and cables.1.2 This specification is intended...

Språk

Publicerad

2002-04-10

Upphävd

2007-02-01

PDF · 468 SEK

Standard · ASTM ASTM D197

Standard Test Method for Sampling and Fineness Test of Pulverized Coal

1.1 This test method covers the determination of the fineness by sieve analysis of coal sampled from a dry pulverizing operation. It is not applicable to products of wet milling or to fines that ha...

Språk

Publicerad

1987-09-25

Upphävd

2007-10-01

PDF · 533 SEK

Standard · ASTM ASTM D409

Standard Test Method for Grindability of Coal by the Hardgrove-Machine Method

1.1 This test method covers the determination of the relative grindability or ease of pulverization of coals in comparison with coals chosen as standards. A prepared and sized sample receives a def...

Språk

Publicerad

2002-04-10

Upphävd

2007-10-01

PDF · 533 SEK

Standard · ASTM ASTM D291

Standard Test Method for Cubic Foot Weight of Crushed Bituminous Coal

1.1 This test method covers two procedures for determining the cubic foot weight of crushed coal less than 1 1/ 2 in. (37 mm) in size, such as is charged into coke ovens, as follows:1.1.1 Procedure...

Språk

Publicerad

1986-09-26

Upphävd

2007-10-01

PDF · 468 SEK

Standard · ASTM ASTM D7105

Standard Test Method for Determining the Adhesive and Cohesive Strength Between Materials in Roofing or Waterproofing Membranes and Systems

1.1 This test method measures the force needed to cause separation of the components of a roofing or a waterproofing membrane system normal (perpendicular) to the plane of the membrane. The separat...

Språk

Publicerad

2007-02-07

PDF · 468 SEK

Standard · ASTM ASTM D4101

Standard Specification for Polypropylene Injection and Extrusion Materials

1.1 This specification covers polypropylene materials suitable for injection molding and extrusion. Polymers consist of homopolymer, copolymers, and elastomer compounded with or without the additio...

Språk

Publicerad

2007-02-07

Upphävd

2007-03-01

PDF · 611 SEK

Standard · ASTM ASTM D2121

Standard Test Methods for Polymer Content of Styrene Monomer and AMS (-Methylstyrene)

1.1 These test methods cover the determination of the polymer content of styrene monomer and AMS (-Methylstyrene). It should be noted, however, that dimers and trimers are not measured by these tes...

Språk

Publicerad

2007-02-07

PDF · 468 SEK

Standard · ASTM ASTM D7317

Standard Test Method for Insolubles in Used Lubricating Oils by Paper Filtration (LMOA Method)

1.1 This test method covers the determination of coagulated pentane insolubles in used lubricating oils by a paper filtration method.1.2 This test method was originally developed by the Fuels, Lubr...

Språk

Publicerad

2007-02-07

Upphävd

2007-07-01

PDF · 468 SEK

Standard · ASTM ASTM F2576

Standard Termninology Relating to Declarable Substances in Materials

1.1 This terminology standard contains terms, definitions, descriptions of terms, nomenclature, and explanations of acronyms and symbols specifically associated with standards under the jurisdictio...

Språk

Publicerad

2007-02-07

Upphävd

2007-05-01

PDF · 468 SEK

Standard · ASTM ASTM B722

Standard Specification for Nickel-Chromium-Molybdenum-Cobalt-Tungsten-Iron-Silicon Alloy (UNS N06333) Seamless Pipe and Tube

1.1 This specification covers alloy N06333 in the form of hot-finished and cold-finished seamless pipe and tube intended for heat-resisting applications and general corrosive service. The general r...

Språk

Publicerad

2007-02-07

PDF · 468 SEK

Standard · ASTM ASTM D910

Standard Specification for Aviation Gasolines

1.1 This specification covers formulating specifications for purchases of aviation gasoline under contract and is intended primarily for use by purchasing agencies.1.2 This specification defines sp...

Språk

Publicerad

2007-02-07

Upphävd

2007-07-15

PDF · 533 SEK

Standard · ASTM ASTM D2276

Standard Test Method for Particulate Contaminant in Aviation Fuel by Line Sampling

1.1 This test method covers the determination of particulate contaminant in aviation turbine fuel using a field monitor.1.2 There are two test methods described. The basic test method is used to ev...

Språk

Publicerad

2007-02-07

PDF · 533 SEK

Standard · ASTM ASTM E427

Standard Practice for Testing for Leaks Using the Halogen Leak Detector(Alkali-Ion Diode)

1.1 This practice covers procedures for testing and locating the sources of gas leaking at the rate of 2.2 10 14 mol/s (5 1010 Std cm3/s). The test may be conducted on any device or component ac...

Språk

Publicerad

2007-02-07

PDF · 533 SEK

Förfina din sökning genom att visa:

...som handlar om: