21293 träffar på

Standard · ASTM ASTM D2921 Standard Test Method for Qualitative Tests for the Presence of Water Repellents and Preservatives in Wood Products 1.1 This test method covers simple qualitative field or laboratory tests to determine water repellency or the presence of chlorinated phenol preservative chemicals in wood products that are spec... Språk Publicerad 2005-05-15

PDF · 468 SEK

Standard · ASTM ASTM D1465 Standard Test Method for Blocking and Picking Points of Petroleum Wax 1.1 This test method covers the determination of the blocking point and picking point of petroleum wax. 1.2 WARNINGMercury has been designated by many regulatory agencies as a hazardous mate Språk Publicerad 2010-09-17

PDF · 468 SEK

Standard · ASTM ASTM D4994 Standard Practice for Recovery of Viruses from Wastewater Sludges 1.1 This practice is used for the recovery of viruses from wastewater sludges and favors the enteroviruses. 1.2 Both procedures are applicable to raw, digested, and dewatered sludges.<table summ... Språk Publicerad 1989-10-27

PDF · 533 SEK

Standard · ASTM ASTM D3853 Standard Terminology Relating to Rubber and Rubber Latices—Abbreviations for Chemicals Used in Compounding 1.1 This terminology is a compilation of abbreviations for accelerators, vulcanizing agents, activators, antidegradants, plasticizers, softeners, processing aids, blowing agents, retarders, isocyan... Språk Publicerad 2012-03-23

PDF · 468 SEK

Standard · ASTM ASTM C538 Standard Test Method for Color Retention of Red, Orange, and Yellow Porcelain Enamels 1.1 This test method covers only porcelain enamels containing the cadmium-sulfide or cadmium sulfo-selenide types of pigments. The purpose of the test is to detect those red, yellow, orange, and s... Språk Publicerad 2004-08-01

PDF · 468 SEK

Standard · ASTM ASTM A553/A553M Standard Specification for Pressure Vessel Plates, Alloy Steel, Quenched and Tempered 8 and 9 Percent Nickel 1.1 This specification covers 8 and 9 % nickel alloy steel plates for use in the water quenched and tempered condition intended for the fabrication of welded pressure vessels. 1.2 Material under ... Språk Publicerad 2011-03-18

PDF · 468 SEK

Standard · ASTM ASTM D5311 Standard Test Method for Load Controlled Cyclic Triaxial Strength of Soil 1.1 This test method covers the determination of the cyclic strength (sometimes called the liquefaction potential) of saturated soils in either intact or reconstituted states by the load-controlle... Språk Publicerad 2012-02-24

PDF · 611 SEK

Standard · ASTM ASTM B607 Standard Specification for Autocatalytic Nickel Boron Coatings for Engineering Use 1.1 Nickel boron coatings are produced by autocatalytic (electroless) deposition from aqueous solutions. These solutions contain either an alkylamineborane or sodium borohydride as a reducing agen... Språk Publicerad 2003-09-10

PDF · 533 SEK

Standard · ASTM ASTM F1738 Standard Test Method for Determination of Deposition of Aerially Applied Oil Spill Dispersants 1.1 This test method covers the measurement of the deposition of an aerially applied dispersant on the surface of the ground or water. The test method of obtaining these measurements is described,... Språk Publicerad 2010-05-17

PDF · 468 SEK

Standard · ASTM ASTM E1656/E1656M Standard Guide for Classification of Automated Pavement Condition Survey Equipment 1.1 This guide covers information for classifying the measurement capability of pavement condition survey equipment or instrumentation that measures longitudinal profile, transverse profile or crac... Språk Publicerad 2011-09-16

PDF · 468 SEK

Standard · ASTM ASTM E2075/E2075M Standard Practice for Verifying the Consistency of AE-Sensor Response Using an Acrylic Rod 1.1 This practice is used for routinely checking the sensitivity of acoustic emission (AE) sensors. It is intended to provide a reliable, precisely specified way of comparing a set of sensors, or t... Språk Publicerad 2010-06-01

PDF · 468 SEK

Standard · ASTM ASTM D1336 Standard Test Method for Distortion of Yarn in Woven Fabrics 1.1 This test method covers the measurement of yarn distortion of one set of yarns over the other in woven cloth following the application of surface friction. This test method especially is applic... Språk Publicerad 2007-10-10

PDF · 468 SEK

Standard · ASTM ASTM E1189 Standard Specification for Micro-Burets (Koch Style) 1.1 This specification covers two styles of glass micro-burets of the “Koch” type for general laboratory use. 1.2 The values stated in SI units are t This specification covers... Språk Publicerad 2005-10-01

PDF · 468 SEK

Standard · ASTM ASTM D4251 Standard Test Method for Active Matter in Anionic Surfactants by Potentiometric Titration 1.1 This test method describes a potentiometric titration procedure for determining the anionic active matter in detergents. It is intended for the analysis of anionic surfactants such as detergent... Språk Publicerad 2009-10-01

PDF · 468 SEK

Standard · ASTM ASTM D3053 Standard Terminology Relating to Carbon Black 1.1 This terminology covers a compilation of definitions of technical terms used in the carbon black and rubber industries. Terms that are generally understood or adequately defined in other readil... Språk Publicerad 2011-04-15

PDF · 468 SEK

Standard · ASTM ASTM D5670 Standard Test Method for Rubber-Determination of Residual Unsaturation in Hydrogenated Nitrile Rubber (HNBR) by Infrared Spectrophotometry 1.1 This test method covers the percentage of residual unsaturation (double bonds in unhydrogenated butadiene) in hydrogenated nitrile rubber and is based on infrared examination of rubber films ca... Språk Publicerad 2004-12-01

PDF · 533 SEK

Standard · ASTM ASTM C891 Standard Practice for Installation of Underground Precast Concrete Utility Structures 1.1 This practice covers the procedures to be followed in the planning, site preparation, and installation of underground precast concrete utility structures. Concrete pipe and box culverts are not... Språk Publicerad 2011-05-20

PDF · 468 SEK

Standard · ASTM ASTM D7301 Standard Specification for Nuclear Graphite Suitable for Components Subjected to Low Neutron Irradiation Dose 1.1 This specification covers the classification, processing, and properties of nuclear grade graphite billets with dimensions sufficient to meet the designer’s requirements for reflecto... Språk Publicerad 2011-12-16

PDF · 533 SEK

Standard · ASTM ASTM D2425 Standard Test Method for Hydrocarbon Types in Middle Distillates by Mass Spectrometry 1.1 This test method covers an analytical scheme using the mass spectrometer to determine the hydrocarbon types present in virgin middle distillates 204 to 343&#x00B0;C (400 to 650&#x00B0;< Språk Publicerad 2009-10-01

PDF · 533 SEK

Standard · ASTM ASTM D1666 Standard Test Methods for Conducting Machining Tests of Wood and Wood-Base Materials 1.1 These test methods cover procedures for planing, routing/shaping, turning, mortising, boring, and sanding, all of which are common wood-working operations used in the manufacture of wood produc... Språk Publicerad 2011-09-16

PDF · 611 SEK

Standard · ASTM ASTM C969M Standard Practice for Infiltration and Exfiltration Acceptance Testing of Installed Precast Concrete Pipe Sewer Lines (Metric) 1.1 This practice covers procedures for testing installed precast concrete pipe sewer lines using either water infiltration or exfiltration acceptance limits to demonstrate the integrity of the in... Språk Publicerad 2002-08-10

PDF · 468 SEK

Standard · ASTM ASTM E734 Standard Specification for Disposable Glass Blood Sample Capillary Tube (Microhematocrit) 1.1 This specification covers disposable glass blood sample capillary tubes for use in microhematocrit procedures. 1.2 The values stated in SI units are to be regarded as standard. No other units o... Språk Publicerad 2010-07-01

PDF · 468 SEK

Standard · ASTM ASTM D4252 Standard Test Methods for Chemical Analysis of Alcohol Ethoxylates and Alkylphenol Ethoxylates 1.1 These test methods cover the various test methods used to evaluate those properties pertinent to the characterization of alcohol ethoxylates and alkylphenol ethoxylates with respect to suitabil... Språk Publicerad 2009-10-01

PDF · 533 SEK

Standard · ASTM ASTM D4103 Standard Practice for Preparation of Substrate Surfaces for Coefficient of Friction Testing 1.1 This practice covers procedures for the preparation of OVCT (Official Vinyl Composition Tile) and wood panels for subsequent use in tests to measure the coefficient of friction. 1.2 This standard Språk Publicerad 1990-06-29

PDF · 468 SEK

Standard · ASTM ASTM E2479 Standard Practice for Measuring the Ultrasonic Velocity in Polyethylene Tank Walls Using Lateral Longitudinal (LCR) Waves 1.1 This practice covers a procedure for measuring the ultrasonic velocities in the outer wall of polyethylene storage tanks. An angle beam lateral longitudinal (LCR) wave is excited with wedges al... Språk Publicerad 2011-09-16

PDF · 533 SEK

Standard · ASTM ASTM D1214 Standard Test Method for Sieve Analysis of Glass Spheres 1.1 This test method covers the sieve analysis of glass spheres used for retroreflective pavements markings and industrial uses. 1.2 The values stated in SI units are to be regarded as the sta... Språk Publicerad 2010-06-18

PDF · 533 SEK

Standard · ASTM ASTM D5348 Standard Test Method for Determination of the Moisture Content of Sulfonated and Sulfated Oils by Distillation with Xylene 1.1 This test method covers the determination of water existing in a sample of sulfonated or sulfated oil, or both, by distilling the sample with a volatile solvent. The test method is applicable o... Språk Publicerad 1995-01-01

PDF · 468 SEK

Standard · ASTM ASTM D1152 Standard Specification for Methanol (Methyl Alcohol) 1.1 This specification covers methanol (99.85 % grade). 1.2 The following applies to all This specification covers methanol (99.85 % grade). The non-volatile matter... Språk Publicerad 2006-04-01

PDF · 468 SEK

Standard · ASTM ASTM G173 Standard Tables for Reference Solar Spectral Irradiances: Direct Normal and Hemispherical on 37° Tilted Surface 1.1 These tables contain terrestrial solar spectral irradiance distributions for use in terrestrial applications that require a standard reference spectral irradiance for hemispher Språk Publicerad 2003-01-10

PDF · 611 SEK

Standard · ASTM ASTM F2658 Standard Specification for Type PSM Poly(Vinyl Chloride) (PVC) SDR 51 and SDR 64 Sewer Pipe and Fittings 1.1 This specification covers requirements and test methods for materials, dimensions, workmanship, flattening resistance, impact resistance, pipe stiffness, extrusion quality, joi This ... Språk Publicerad 2007-09-05

PDF · 533 SEK

• < Föregående
• 488
• 489
• 490
• 491
• 492
• 493
• 494
• 495
• 496
• 497
• Nästa >